In upholstery application especially in automobiles and aircraft, low fogging is required.
低雾化性是生产家具革,特别是汽车、飞机等座垫用革的特殊要求。
The techniques of low volume spraying and air-assisted boom spraying were applied at the same time in this system.
采用机电一体化技术,气流辅助技术,低量喷雾技术为中国设计生产出第一代用于水稻病虫害防治的喷杆喷雾机,提高了插秧机通用底盘的利用率;作业效率2hm2/h(作业速度0。
The Cryogenic Mist Jet Cooling Technology in Turning Process of Titanium Alloy
钛合金车削中的低温喷雾射流冷却技术
Cryogenic Mist Jet Impinging Cooling and Its Application in Machining of Titanium Alloy;
低温喷雾射流冷却技术及其在钛合金机械加工中的应用
Thermal Analysis of Cryogenic Mist Jet Impinging Cooling and Its Application in Turnning of Titanium Alloy;
低温喷雾射流冷却技术及其在钛合金车削加工中的应用
Fundamental Research on Cryogenic Pneumatic Mist Jet Impinging Cooling Based on Green Manufacturing;
基于绿色制造的低温气动喷雾冷却的基础研究
Experimental Investigation of Non-boiling Spray Cooling with Low Surface Temperature and Big Water Flow Rate
低温表面大流量无沸腾喷雾冷却试验研究
Methods Residual spraying with ULV sprayer.
方法 用超低容量喷雾器进行雾化滞留喷洒。
Research on Operation Heat Accumulation and Spray Cooling Feasibility in Chongming Tunnel;
崇明隧道运营累积温升及喷雾降温可行性研究
A liquid medication applied by spraying.
喷雾剂喷雾的液体制剂
Preparation of Heat-resistant Microencapsulated Sweet Orange Oil by Spray-drying
喷雾干燥法制备耐高温型微胶囊化甜橙油
The Development of Temperature Control System Based on PID Self-tunning Technology in Electrospray Ionization Source;
电喷雾源中基于PID自整定温度控制系统的研制
Humidity-temperature measurement and drying characteristics in multiphase flow region of spray
喷雾多相并存区温湿度测量方法及干燥特性
CFD Simulation of Water Spray Downstream in Gas Cooling of Marine Engine
舰船发动机排气管内顺流喷雾降温的CFD分析
This air improves the atomization of fuel coming fron the low-speed port.
这些空气改善了从低速出口喷出的燃料的雾化。
Experimental Investigation on the Combustion of Higher Efficiency、Lower Emission Effervescent Atomizer;
高效、低污染气泡雾化喷嘴燃烧特性实验研究
The Numerical Simulation Study of the Inner Flow in the Air-assisted Hydraulic Ultra-low Volume Sprayer Device;
风送式超低量喷雾装置内流场数值模拟研究
Numerical Study on Liquid-solid Two-phase Flow in Low-pressure Swirl Atomizing Nozzle
低压旋流雾化喷嘴内液固两相流动的数值研究
Numerical simulation of impedance characteristic of low-frequency ultrasonic nozzle for aeroponic culture
低频超声雾化栽培喷头阻抗特性的数值模拟
aperture atomizer
喷孔式喷油嘴喷雾器
本网站所收集内容来自网友分享仅供参考,实际请以各学校实际公布信息为主!内容侵权及错误投诉:1553292129@qq.com
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号