In practical production,because wire rods had some defects,so break occurred in Y type wire cold rolling mill in the course of rolling The reasons of break of cold rolled steel wire have been analyzed Some requirements on structure,nature of material etc of wire rods have been put forwar
Y型冷轧钢丝机组在实际生产中由于盘条存在着某些缺陷,在轧制过程中发生断裂。
Spherical annealing structure of 45 steel used for cold rolled screw,compared with nomalizing,can improve the rolling performance,the rolling quality and the roller’s service life.
冷轧丝杆所用 45钢 ,采用球化退火组织比正火组织轧制性能好 ,轧制件质量好 ,轧辊寿命长。
The corrosion resistance of cold-rolled steel sheet was studied by electrochemical tests including linear polarization(LP)and electrochemical impedance spectroscopy(EIS).
采用线性极化、电化学交流阻抗等方法研究了冷轧钢板的耐蚀性能,同时使用线性扫描伏安法获得了冷轧钢板表面氧化物的种类及还原电位,分析了其与冷轧钢板耐蚀性能之间的关系。
An effective coupling FEA model was established to compute temperature and heat stress, which is the main reason causing sticking problem of cold-rolled strip during annealing.
针对冷轧钢卷退火过程中引起粘结的主要原因-高温和压力,建立有效的计算模型,并根据实验给出的经验公式和实际工作状况,确定钢卷的边界条件和相应的物理参数。
Continuously electrolytic zinc-coated cold-rolled steel sheets and strips
GB/T15675-1995连续电镀锌冷轧钢板及钢带
Comparison of the Properties of 2205 Duplex Stainless Steel Cold Rolled Plates
国内外2205双相不锈钢冷轧钢板的性能比较
Cold rolled stainless steel clad sheets and strips
GB/T17102-1997不锈复合钢冷轧薄钢板和钢带
Cold rolled sheets and strips for civil enameling
GB/T13790-1992日用搪瓷用冷轧薄钢板和钢带
Cold rolled sheets and strips for deep drawing
GB/T5213-1985深冲压用冷轧薄钢板和钢带
Study on Monitoring Tactic for the Plate Thickness and Crown of Cold Rolling Strip;
冷轧带钢板厚、板凸度监测策略的研究
The Cold Steel Plate Ridging Analysis and Process Improvement of SUS444
SUS444不锈钢冷轧板板纹分析及工艺改进
Analysis on the Rusty Spots on the Cold-rolled Strip in Baotou Steel
包钢冷轧板板面锈斑产生原因及改进
Texture Evolution during Annealing in Warm Rolled and Cold Rolled Ti-IF Steel
冷轧后退火过程中温轧Ti-IF钢板织构的演变
The Practice for Production of Sheet Steel of Automobile with Compact Strip Production Hot Strips
以CSP热轧板为原料汽车冲压用冷轧钢生产实践
A Brief Introduction to the Compiling of Acid Rolling Plan Regarding MES System Applied in Tangshan Iron and Steel Group Strip Cold Rolling Plant
简析唐钢冷轧薄板厂MES系统酸轧计划的编制
Influence of the Precipitation of Dissolved Elements in the Hot Rolled Steel Band on the Cold Rolled Texture
热轧钢板固溶元素析出对冷轧织构的影响
Cold-rolled quality carbon structural steel sheets and strips
GB/T13237-1991优质碳素结构钢冷轧薄钢板和钢带
Study on Effects of Cold Rolling-Process on Microstructure and Properties of Nb+Ti- Interstitial Free Steel;
Nb+Ti-IF钢薄板冷轧工艺及组织性能研究
Research of Batch Annealing Process for Cold Rolled Adding P High Strength IF Steel Plate
加磷高强IF钢冷轧板罩式退火工艺研究
The Effect of Carbon Content on Properties of IF Steel
碳含量对IF钢冷轧板力学性能影响分析
Design Characteristics of Continuous Annealing Line for Cold-rolled Steel Sheet of Maanshan Iron & Steel Co.,Ltd
马钢2130mm冷轧薄板连续退火线设计特点
Recrystallization and Structure of Microalloyed High Strength Steel Sheet After Cold Rolling
冷轧高强度汽车钢板的再结晶及组织
本网站所收集内容来自网友分享仅供参考,实际请以各学校实际公布信息为主!内容侵权及错误投诉:1553292129@qq.com
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号