According to the basic theory and principle of robust control, the robust control method suited to bionic thermostable structure was presented.
根据鲁棒控制的基本理论及原理,提出适合仿生热稳定构件控制系统的鲁棒控制方法。
The results showed that the compression heat build-up of tread decreased remarkably by combining silica 175GR and carbon black with a proper blending ratio,and at the same time,the tear resistance and rebound resilience improved significantly,the tensile strength and elongation at break increased,while the flex crack resistance was also improved slightly.
回归分析试验结果表明,白炭黑175GR与炭黑采用适当的比例并用,可使胎面胶压缩生热明显降低,抗撕裂性能和弹性显著提高,拉伸强度和拉断伸长率有所提高,抗屈挠龟裂性能有所改善。
The results showed that NR/JSR T5800 could fulfill the requirement of the tire compounds and at the same time the heat build-up of the compounds was the least,the wet traction of the NR/JSR T5800 compounds was the best,while the rolling resistance was the least.
结果表明,NR/JSR T5800并用胶在满足轮胎基本物性下,其压缩生热最小、抗湿滑性最好、滚动阻力最小,能够有效地解决轮胎胎面胶滚动阻力和抗湿滑性之间的矛盾,满足高性能轮胎发展的需要。
The test results showed that,by increasing the additional level of sulfur and accelerator,the curing rate of sidewall compound increased,the modulus and the flexing resistance improved,the heat build-up decreased,and other properties changed little.
结果表明,通过适当增大硫黄和促进剂用量,胎侧胶的硫化速度加快、定伸应力和耐屈挠性能提高、生热降低,其它性能变化不大,成品轮胎的高速耐久性能显著改善。
The test results showed that the processibility of compound improved,the modulus at 300% elongation and Shore A hardness of vulcanizate increased,the tensile set at break and Goodrich heat build up of vulcanizate decreased,the heat resistance and wear resistance of vulcanizate and the performance of finished tire improved by adding 1 5 phr of modulus promoter HMZ to truck tire tread.
试验结果表明 ,在载重轮胎胎面胶中加入 1 5份模量增强剂HMZ ,可改善胶料的加工工艺性能 ,增大硫化胶的 30 0 %定伸应力和邵尔A型硬度 ,减小扯断永久变形和固特里奇生热 ,提高耐热性、耐磨性以及轮胎成品性能。
The chain structures of S SBR2305,Buna SL25 1 and E SBR1500 were analysed by FTIR,and the influences of these three SBRs on the wear resistance,heat build up,rolling resistance and wet traction of NR/SBR blend were investigated by the compression heat build up test with constant load,DMA etc.
采用傅立叶变换红外光谱 (FTIR)分析了溶聚丁苯橡胶 (S SBR)S SBR2 30 5、BunaSL2 5 1及乳聚丁苯橡胶E SBR15 0 0 3种SBR的链化学结构 ,采用定负荷压缩生热、动态力学谱 (DMA)等方法研究了 3种SBR对NR/SBR并用胶耐磨性、生热、滚动阻力及抗湿滑性的影响。
The dynamic mechanical properties and heat build up of black filled rubber are predicted at different load conditions based on the concept of strain amplification.
基于应变放大因子的概念,对炭黑填充橡胶的动态力学性能和在不同外载条件下的生热性能作了分析预报。
Relating to or generating heat or calories.
热的,生热的与热或热量相关的,或产生热量的
Dowtherm heating
道生加热(使用道生热载体进行加热)
calorigenic action
生热作用, 产热作用
Caused by or generating heat.
由热引起的由热引起的,或产生热量的
generate heat, electricity, power, etc
产生热、 电、 动力等
To warm by rubbing, as with the hands.
摩擦生热摩擦以生热,尤指用手摩擦
Relating to, producing, or affected by fever.
热病的有关或产生热病的或被热病影响的
Effect of Thermal Conductive Filler on Heat Build-up and Thermal Conductivity of NR/BR Vulcanizate
导热填料对NR/BR硫化胶的生热和导热的影响
The body must dissipate heat as fast as it produces it.
人体散发热量必须和产生热量一样快。
The Hot Delivery and Hot Charging at Masteel's 2250mm Hot Rolling Mill
马钢2250mm热轧热送热装生产模式研究
Characterized by or causing the absorption of heat;endoergic.
吸热的具有吸热特性的或由吸热产生的;吸热的
A light produced by a body heated to luminosity;incandescence.
白热,炽热由一加热到发光的物体产生的光;白热
Of, occurring in, or characteristic of the Tropics.
热带的热带的,发生于热带的,有热带特性的
higher heating value; gross heating value - GHV; gross calorific value - GCV: Total amount of heat produced by combustion.
高热值;总热值(简写为GHV,GCV):燃烧产生的总热量。
Thermodynamic analysis of waste heat recovery in one-step phosphorous acid production by BEP
一步法热法磷酸生产余热回收的热力学分析
The Design and Study of Biomass Pyrolysis Carrier Heating Device;
生物质热裂解热载体加热装置的设计与研究
Analysis on Heat of Circulating Hot Air Drying Cylinder of Plant-mixed Hot Recycling System
厂拌热再生系统中循环热风烘干筒传热学分析
electricity produced by heat (as in a thermocouple).
由热产生的电(在一个热电偶内)。
本网站所收集内容来自网友分享仅供参考,实际请以各学校实际公布信息为主!内容侵权及错误投诉:1553292129@qq.com
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号