In accordance with the expression of the correction of rod length to the blow counts of standard penetration test (SPT) in the "Code of Geotechnical Investigation" (GB 50021-94) ;in this paper, the author poses his viewpoint of the correction of rod length for the value of blow counts during conducting SPT is necessary.
本文根据《岩土工程勘察规范》(GB50021—94)关于标准贯入试验锤击数(下称标贯击数)杆长校正问题的表述,对标贯锤击数是否应作杆长校正提出了作者的看法,认为在目前情况下,对标贯击数值进行杆长校正是必要的。
Research on temperature calibration with hot-film anemometer;
热膜风速计温度校正研究
Filtering and temperature correction algorithm for smog interference in temperature measurement using CCD two-color thermometry
CCD比色测温中烟雾干扰的滤波与温度校正算法
Research on Temperature Calibration and New Enzyme in Determination of Organophosphate Pesticide Residues;
有机磷农药残留检测的温度校正和新酶源研究
Study on Emendation Method of EPDM Back-face Temperature in SRR
冲压发动机三元乙丙热防护材料背面温度校正方法研究
Nonlinear emendation for temperature measure based on microprocessor
基于微处理器的温度测量非线性校正
Determination of electrolyte temperature when correcting reference temperature during capacity test of acid miner's lamp
酸性矿灯容量试验中校正基准温度时电解液温度的确定
Self-Tuning Control of Temperature System Based on Pole Placement Algorithm;
基于极点配置算法的自校正温度控制系统
Temperature Character Analysis and Adjustment Technique for the Detector of Aerial Gamma-ray Spectrometric
航空γ能谱探头温度效应及校正技术研究
Using CPSO-SVM and data fusion to calibrate temperature characteristic of thermal sensor
热导传感器温度特性的CPSO-SVM数据融合校正
With A Two-Order Nonlinear Correction of the RTD Temperature Transmitter
具有二阶非线性校正功能的铂电阻温度变送器
Analysis of the Zero Calibration and Temperature Compensation of Infrared Methane Transducer
红外瓦斯传感器零点校正及温度补偿分析
The Design of Temperature Control Systemfor Refining Adhesive Based on Self-tuning PID Control
基于自校正PID的胶粘剂生产过程温度控制系统
Calibration environments( laboratory room temperature and relative humidity) requirements are well defined and documented.
对校正环境(验室的温度和相对湿度)要求清析定义于指引档中.
a thermometer calibrated in degrees centigrade.
用百分度校准的温度计。
The Calibration of Pt-30Rh/Pt-6Rh Thermocouples by "Wire Method" at the Palladium Point Under Normal Atmospherie Pressure
用"熔线法"对铂-30铑/铂-6铑热电偶在钯点温度的校正
Research on the Isothermal Adjustment Technology and Parameters for Improving the Accuracy of TC11 Alloy;
等温校正工艺及参数对改善TC11钛合金叶片精确度的作用研究
normal pressure and temperature
额定压力及温度正常压力和温度
run until the normal working temperature is reached.
运转到温度达到正常的工作温度。
sea-air temperature difference correction
海水空气温度差修正
本网站所收集内容来自网友分享仅供参考,实际请以各学校实际公布信息为主!内容侵权及错误投诉:1553292129@qq.com
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号