Study on characteristic of desulphurization gypsum and its influence on grinding process and cement performance
脱硫石膏粒径分布及其水分对水泥粉磨过程和性能的影响
This paper is a survey of the recent researches on the area of grinding processes.
综述流程工业中的粉磨过程,分析模型建立的方式,论述现有最佳负荷点和当前负荷值检测方法的优缺点,提出粉磨过程复合控制器的整体思路。
Aiming at the problem of information isolated island in the monitoring and control system of modern detergent manufacturing process,the multi-Agent technology was applied.
针对现代洗衣粉生产过程监控系统中的"信息化孤岛"问题,将多Agent技术应用到洗衣粉生产过程的监控中。
APPLICATION RESEARCH OF GRINDING AIDS FOR MULLITE GRINDING PROCESS
莫来石粉磨过程中助磨剂的应用研究
Research of Optimal Control System to Cement Raw Mill Circuit
水泥生产中粉磨过程优化控制系统的研究
Study on characteristic of desulphurization gypsum and its influence on grinding process and cement performance
脱硫石膏粒径分布及其水分对水泥粉磨过程和性能的影响
The act or process of grinding, especially grinding grain into flour or meal.
磨坊,碾谷,碾磨碾磨的行为或过程,尤指将谷物磨成细粉或粗粉
Hybrid Intelligent Modeling of Ball Mill Coal Pulverizing Process
钢球磨煤机制粉过程的混合智能建模
Tribochemical Effect of Ni/Si Power During Ball Milling;
Ni/Si元素粉末球磨过程中的摩擦化学研究
Study on Preparation Process of CNTs/Al Composite Powder by Mechanical Milling
机械球磨法制备CNTs/Al复合粉末的工艺过程研究
Characteristics and pressing-sintering process of Cu-Zr powder formed by high-energy ball milling
高能球磨Cu-Zr复合粉体的特性与压制烧结过程研究
Effect of aqueous imidazoline corrosion inhibitor on properties of aluminum powder in ball milling
球磨过程中水性咪唑啉类缓蚀剂对铝粉性能的影响
Study on Mechanical Grinding Activation Fly Ash and Acid Leaching of Aluminium Oxide
粉煤灰酸法提取氧化铝过程的机械研磨活化研究
fine powdery foodstuff obtained by grinding and sifting the meal of a cereal grain.
谷类粗粉经过碾磨而成的细粉。
The Study on Formation Process of Three Kinds of the Typical Abrasive Debris
三种典型磨粒磨损磨屑形成过程的研究
Establishment on Grinding Model of Y7125 Gear Grinder and Study on Heat State of Gear Grinding Process;
Y7125磨齿机磨削模型建立与磨齿过程热状态研究
Taking example by the design of control system of the electronic control and electromotion flour mill(EEFM),general development process of embedded system is introduced in the paper.
本文以电控电动磨粉机控制系统设计为例,介绍了嵌入式系统开发的一般过程。
Grain Size and Structure Change of Al Phase during the Process of Nanosize Al_2O_3/Al Composite Powders Prepared by High-Energy Ball Milling
高能球磨制备纳米级Al_2O_3/Al复合粉体过程中铝相晶粒尺寸和结构的变化
To reduce to fragments, shreds, or powder by rubbing against an abrasive surface.
磨碎通过在粗糙表面上磨擦使…成为碎片、细条或粉末
conversion of starch to sugar.
把淀粉转变为糖的过程。
Code for construction and acceptance of crusher and mill equipment installation engineering
破碎粉磨设备安装工程施工及验收规范
本网站所收集内容来自网友分享仅供参考,实际请以各学校实际公布信息为主!内容侵权及错误投诉:1553292129@qq.com
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号